NeXTStation Turbo Color (ADB)

From Caps Wiki
Revision as of 01:22, 11 February 2022 by Chartreuse (talk | contribs) (Added images)
Jump to navigation Jump to search
For more information, see this article's corresponding Wikipedia page: NeXTstation.
NeXTStation Turbo Color (ADB)
[[File:
NeXTStation Turbo Color
|300px]]
Preliminary Information
Release Year 1992/1993
Leak Risk High
Batteries BR-2/3A Lithium Primary 3V
Mounting Technology Through Hole, SMD
Capacitor Types Aluminum Electrolytic, Ceramic
Destructive Entry No

Known Issues

Disassembly Notes

Disassembling the NeXTStation is extremely simple, and is designed for servicing. To remove the motherboard only a total of 4 screws need to be removed.

First unplug the unit, removing any other cables or adapters connected to it.

Undo the single Phillips screw on the back. Then lift the top cover up and off.

Once inside, disconnect the SCSI ribbon cable and molex power for the hard drive from the motherboard.

Remove the single Philips screw holding the hard drive mount in place. Lift up from the screw side and the hard drive tray will rotate, hinging on the opposite side before lifting out.

Disconnect the floppy ribbon from the mainboard (there is no separate power connector, power is over this ribbon).

Remove the single Phillips screw holding the floppy drive in place, and lift and rotate it the same as the hard drive to remove.

Disconnect the 2 pin fan header, and the power supply connector. Both lift straight up, the PSU one may take some force. Remember to hold down the motherboard while doing so.

Finally remove the single Phillips screw holding down the motherboard, and lift from the front edge. The board will come right out, mind the connectors at the back.

Original Parts

Mainboard

Internals with cover removed. (After recapping)
Internals with cover removed. (After recapping)

PN-4244.00

Only the SMD caps seem to leak, the through-hole ones appeared just fine with no sign of leakage below them when removed. However they are very easy to desolder and there are only 3, so the cost of doing so is minimal.


While a multi-layer board, the through hole capacitors are very easy to desolder owing to large through holes. You are very unlikely to damage the board recapping with only basic tools.

NOTE: No components have reference designators and polarity is NOT marked for capacitors. Through hole capacitors should have their positive leg in the square pad hole. When viewed with the connectors at the back, all surface mount capacitors should have the negative stripe to the right, and the through hole ones to the left.

Capacitor Specifications and Footprint Information
RefDes Qty Capacitance Voltage Mount Diameter/Size Height Pin Pitch Temp Type Brand Series
SMD 8 47uF 16v SMD 6.30mm 7.00mm 6.60mm x 6.60mm Electrolytic Unknown (Marked w with overbar) (W2) W2
TH 3 220uF 25v Through Hole 10.00mm 13.00mm 5.00mm 105°C Electrolytic Matsushita/PanasonicMatsushita/Panasonic HFQ

Replacement Parts

Mainboard

Capacitors
RefDes Qty Compatible Part Number Order Links
SMD 8 UCW1C470MCL1GS Digikey
TH 3 EEU-FC1V221 Digikey

Replacement TH parts number is 35v instead of 25v, but works fine and is low ESR.

If parts are not available or different selection is preferred, you can use the values in the Original Parts section to perform a parametric search

Related Links

References