Disassembly:Nintendo Entertainment System

Step 1: Remove Top Housing

• Remove six 13.25mm Phillips screws on the bottom of the system.
  • The screws are recessed about 40mm.
• Once all screws are removed, simply lift the bottom half away from the top housing.

Step 2: Remove Top RF Shield

• Remove four 13.25mm Phillips screws from the four corners of the cartridge tray.
  • Your system may only have two screws on the bottom
• Remove two 17.25mm Phillips screws from the top of cartridge tray.
• Once free, slide the cartridge tray towards you and then lift slightly in the front to remove.

Step 3: Remove Cartridge Tray

• Remove four 13.25mm Phillips screws from the four corners of the cartridge tray.
  • Your system may only have two screws on the bottom
• Remove two 17.25mm Phillips screws from the top of cartridge tray.
• Once free, slide the cartridge tray towards you and then lift slightly in the front to remove.

Step 4: Remove Motherboard Pt. 1

• Remove three 13.25mm Phillips screws to free the motherboard from the bottom housing.
• Carefully lift the motherboard and turn it over to find the wired connections.

Step 5: Remove Motherboard Pt. 2

• Disconnect the wired connections from the motherboard.
  • Player 1 (Shorter wires)
  • Player 2 (Longer wires)
  • Power/Reset Buttons

Step 6: Remove Bottom RF Shield

• The bottom RF shield is held on by tension around the expansion port. Lift the shield up and away from the motherboard.

Step 7: Remove 72-Pin Connector

• To remove the 72-Pin connector, apply force to each edge and slide the connector off the contacts on the motherboard.

Step 8: Remove Power/Reset Buttons

• Remove two 13.25mm Phillips screws from the button assembly. Lift slightly in the back and then up and away from the housing to remove.

Step 9: Remove Controller Ports

• Remove two 7.25mm Phillips screws from the bottom of the system. Lift the controller port faceplate up and away.
• Remove the controller ports by feeding them through the port holes to the front of the housing.
• When reassembling, Player 1 (Left) has shorter wires that Player 2 (Right).

Step 10: Remove Plastic Door and Accent Pieces

• Remove seven 7.25mm small flathead screws from the inside of the top housing.
• Two of these screws also hold a spring for the door. When reassembling, refer to the keyed shape of the plastic to orient these correctly.

Step 11: Disassembly Complete!

• Screw List
  • (19x) 13.25mm Phillips
  • (2x) 17.25mm Phillips
  • (2x) 7.25mm Phillips (Silver, large cap)
  • (7x) 7.25mm Flathead (Silver, small)