Apple IIe Aftermarket PSU (Delta Electronics)
- For more information, see this article's corresponding Wikipedia page: Device.
.jpg)
This is the page for the Delta Electronics MW 302 AP aftermarket power supply for the Apple IIe
Power supply should normally output voltages specified on outer casing (+/-5VDC and +/-12VDC) in an unloaded condition.
Known Issues
Non functional / clicking when powered on
NOTE: Many Apple IIe power supplies (Astec branded) click and do not provide proper output voltages when unloaded, but operate properly when connected to a motherboard. Some, however, provide constant output regardless. Limited experience with aftermarket PSU's suggest a constant output is to be expected.
Causes
- Blown / failed electrolytic capacitors
Solutions
- Replace electrolytic capacitors
Disassembly Notes
Seven screws to disassemble case. Will need to remove power switch from end to remove board from enclosure. Desolder wires from NEMA plug connection to separate completely.
Original Parts
Power Supply PCB
Underside stamped with "MW 302 AP". "Delta Electronics" name found on back of NEMA plug
| RefDes | Qty | Capacitance | Voltage | Diameter/Size | Height | Lead Spacing | Temp | Type | Brand |
|---|---|---|---|---|---|---|---|---|---|
| C! | 1 | 0.1 µF | 250VAC | 17.8mm | 12.5mm | 15.6mm | 0 °C | Film | ISKRA |
| C2, C3 | 2 | 4700 pF | 250VAC | 13mm | 11mm | 10.5mm | 0 °C | Film | ISKRA |
| C4, C5 | 2 | 100 µF | 200V | 16.2mm | 33mm | 7.8mm | 85 °C | Electrolytic | Jamicon |
| C6 | 1 | 100 µF | 25V | 6.6mm | 11.6mm | 3.4mm | 85 °C | Electrolytic | N/A |
| C7, C8, C12 | 3 | 10 µF | 63V | 5.2mm | 11.2mm | 2.9mm | 85 °C | Electrolyitic | N/a |
Replacement Parts
Basic PCB Name
| RefDes | Qty | Compatible Part Number | Order Links |
|---|---|---|---|
| Digikey |
If parts are not available or different selection is preferred, you can use the values in the Original Parts section to perform a parametric search.
Kits
- Digikey BOM: https://www.digikey.com/